Help Tuning Bambu PETG-CF - Bambu Lab X1 Series - Bambu Lab Community Forum

I need help with tuning my Bambu PETG-CF. In this thread I have the same model printed using orca-slicer calibrated settings, as well as the stock Bambu PETG-CF presets I went through the OrcaSlicer calibration process and did some tuning, but my print ended up quite bad! Filament was dried for 8h at 65c as recommended, resulting in a RH of about 15% in the chamber it was dried in. Placed in an AMS at 10% RH with extra drying beads. Model tested: 2x2 gridfinity bin generated from openscad h

The Bambulab X1 / P1P are PLA ONLY printers! Please proof it wrong! - Bambu Lab X1 Series - Bambu Lab Community Forum

PETG (PolyLite) Adhesion Poblems / Wobbly Brim - Troubleshooting - Bambu Lab Community Forum

Latest Bambu Lab X1-Carbon topics - Bambu Lab Community Forum

Bambu Lab PETG Basic - Troubleshooting - Bambu Lab Community Forum

Prints getting worse - Troubleshooting - Bambu Lab Community Forum

Bambu Lab X1 Series, Desktop 3D Printer

Prints getting worse - Troubleshooting - Bambu Lab Community Forum

Solution to printing Bambu PETG-CF with X1C (.4 and .6 Nozzle) - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Nozzle collects filament when printing with PETG-CF - Bambu Lab X1-Carbon - Bambu Lab Community Forum