ctt-astana.kz
Casa
Trova
Casapetg sunluStringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/FixMyPrint
Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/FixMyPrint

4.9
(150)
Scrivi Recensione
Di più
€ 24.99
Nel carrello
In Magazzino
Descrizione

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Suggerisci ricerche
Potrebbe piacerti anche