POE / CCTV Camera Splitter Adapter For 2 Devices On 1 Network Cable

POE / CCTV Camera Splitter Adapter for 2 Devices on 1 Network Cable | Network Cable Splitter Use this combiner and splitter cable kit to connect 2x Network

Features:, brand new and high quality, The product can transfer 2 network devices using one Ethernet cable. Save on wiring costs., Suitable for

POE Splitter 1-To-2 Saving Network Cable Three-way RJ45 Connector For Security Camera Router Wrieless Security Camera

Feed two PoE cameras with one network cable

PoE Power Splitter

splitting 1 Ethernet cable to 2 cameras

Allows you to run 1 cable run to the switch for 2 cameras that are near each other, saving on time and material costs. Set consists of a sender Combiner unit and a receiver Splitter unit. Plug Combiner unit into 2 open ports on your POE switch or POE NVR. Run one long cable to the location that has the cameras that are nearby each other and plug it into the Splitter. Connect 2 short cables to the Splitter unit and connect the other ends to your camera. Done! Reduces cabling costs.

IPCamPower PoE Combiner Splitter Adapter, Run 2 IP Cameras on 1 Cable

Allows you to run 1 cable run to the switch for 2 cameras that are near each other, saving on time and material costs. Set consists of a sender

POE Combiner Splitter Adapter, Run 2 IP Cameras on 1 Cable, Works on All POE Switches, POE NVR and POE Cameras, Mode A and B POE Compatible

This is for driving two POE devices off one cable. If you have an extremely long run for one camera and you needed to add another, this would be a great solution. Plugged into two POE+ ports at the switch which uses one CAT6 cable and at the far end it splits to two POE ports that you have a splitter for Ethernet and 12-Volt to run a powered mic and camera and the other is just running another POE camera.

SPT RJ45 Ethernet Cable Combiner Splitter Kit (2-Pair)

GAF-5v10W POE Splitter PoE separator, 1.35x3.5mm Male Connector, Gigab – poe -world

Support international standard IEEE802.3 af(15.4W). POE port Support 10/100Mbps data transmission. Transfer Rate: 10/100Mbps, Standard: IEEE 802.3 I,

Active PoE Splitter 12V 1A Output with IEEE 802.3af Standard Compliant 10,100Mbps Power Over Ethernet Splitter Adapter for Security IP Camera CCTV

POE Splitter 2-in-1 network cabling connector three-way RJ45 connector For HD IP Camera CCTV Accessories

The PT-104 is a 1 to 4 port DC power splitter cable that is typically used to share a low voltage power source with up to four devices such as 12 Volt DC security cameras.

1 to 4 Port DC Power Splitter Cable, 2.1mm Power Lead Plugs 12 Volt DC

1 to 2 Adapter Network Splitter Poe Switch Connector Rj45 Outdoor Waterproof One Wire Dual Purpose Poe Synthesizer Separator. RJ45 Ethernet splitter

POE Splitter RJ45 2-in-1 Network Cabling Connector For Security Camera Install A