Trouble with 12V Relay attached to Pump - Arduino MEGA2560 - Project Guidance - Arduino Forum

I have attached to my Arduino a 2 Channel 12V Relay. Currently the red light on the Relay is working as my program switches LOW and HIGH every 5 seconds, so I know it's communicating. My 12VDC/AC power supply is plugged in the + is spliced in through the orange wire connected to the COM2. On the NO2 I have the +(pos) going to the pump. The -(neg) of the pump is connected to the power supplies -(neg). For some reason I get no response from the NO2 switching on or off. When the red light on the

Problems using relay - Project Guidance - Arduino Forum

Trouble with 12V Relay attached to Pump - Arduino MEGA2560 - Project Guidance - Arduino Forum

12v Relay issue - Hardware - Arduino Forum

12V Water Pump Controlled by Arduino and Relay Won't Work - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino power shutdown when relay connected - Project Guidance - Arduino Forum

40 Awesome Arduino Projects That You Must Try 2023: Get Started with DIY Electronics and Programmable Circuits! - Latest Open Tech From Seeed

DIY: Relay Switch Motor Controller - Arduino : 4 Steps (with Pictures) - Instructables

Two relay,two water pump and one battery - Sensors - Arduino Forum

Using 12 volt relay on Arduino Mega - General Electronics - Arduino Forum

How a Relay Module Works and Interfacing a Single Channel Relay Module with Arduino

YourDuinoEngStarter - ArduinoInfo